Extra 20% off at checkout · Use code SAVE20
CarCover.ca
Installation guide

Installing your heavy-duty wind straps

Wind straps are the upgrade for exposed parking: open lots, coastal streets and anywhere gusts get under a cover. They go on over the fitted cover in about a minute, no tools, and work with every cover we sell.

Fit the cover first. Wind straps go on last, over the cover, after the built-in front and rear straps are already clipped.

1–2 minutes1 personNo tools needed4 steps
What's in the box
2 × Heavy-duty wind straps
2 × Quick-release buckles (attached)
Step by step

The install, start to finish

1–2 minutes, 1 person. Straps, buckles and protectors are all included.

1
Drape the first strap

Lay one strap across the cover about a third of the way back from the front, so it crosses the roofline and hangs evenly on both sides.

2
Pass it underneath

Slide or toss the buckle end under the vehicle to the other side. On a low car it helps to feed it through with the tail.

3
Clip and cinch

Click the buckle together at the side of the vehicle, on the fabric and never against paint, then pull the tail until the strap sits snug and the cover dimples slightly.

4
Repeat at the rear

Fit the second strap a third of the way forward from the rear, cinch it, then walk around once: no slack, no flapping edges.

Read this first

The don'ts that keep cover and vehicle perfect

Straps go over the cover, never against bare paint
Keep the webbing clear of the exhaust: a hot tailpipe can melt it
Position buckles at the side of the vehicle, on fabric, not on a painted panel
Snug is right, crushing is not: over-tightening stresses the cover’s seams
Re-check tension after the first windy day and re-cinch if the strap has settled
Wind straps secure the cover, not the vehicle: never use them as transport tie-downs
Taking it off

Removal & storage

Press the buckle release, pull the strap out from under the vehicle, and roll each strap around its buckle so the pair stays untangled in the cover’s storage bag.

Make sure the cover is completely dry before you put it in the bag. A damp cover in a closed bag will grow mildew.

Keeping it fresh

Cleaning

Wipe the webbing with a damp cloth and mild soap when it picks up road grime, and let it air-dry before storage. Grit on a strap works like sandpaper on the cover under it.

  • No bleach, harsh soaps or fabric softeners
  • Never machine wash, machine dry or iron
  • Air-dry completely before it goes in the bag

Quick answers

Do wind straps replace the built-in straps?+

No, they add to them. The built-in front and rear straps handle everyday weather; wind straps anchor the cover across the middle where gusts try to balloon it. Use both together in exposed spots.

How tight should they be?+

Cinch until the strap is snug and the cover dimples slightly under it. If the fabric is stretched drum-tight or the seams pull, back it off: the strap should stop the cover moving, not crush it.

Will the straps or buckles scratch my paint?+

Not when fitted right. The webbing lies on the cover, never on bare paint, and the buckle should be positioned at the side of the vehicle where it rests on fabric. If a buckle lands on a painted edge, rotate the strap until it does not.

Do they fit every cover and vehicle?+

Yes. The straps are independent of the cover, so they work with every grade we sell, on cars, trucks, SUVs, limousines and hearses. On a stretch limousine, use the pair toward the front and rear thirds of the body.

More guides
Need help deciding?

A real person, in under a minute.

Fit questions, grade advice, order help, pick your channel.

Risk-free
Try it at home
30-day money back

Put it on your car for a full month, return it if it's not right.

Fastest
Call us now
1-800-640-9877

Cover specialists pick up 9 AM to midnight ET, 7 days a week.